wifidog - openwrt 设置

OPENWRT设置之命令行下简单配置有线和无线：
先配置有线
设置lan ip(即访问路由的ip)

uci set network.lan.ipaddr=[lan ip]

pppoe用户

uci set network.wan.proto=pppoe    //设置wan口类型为pppoe
uci set network.wan.username=[上网帐户]
uci set network.wan.password=[上网密码]    //这两行设置pppoe用户名和密码

如果要挂在上级路由下面就这样

uci set network.wan.proto=none    //关掉wan
uci set network.lan.gateway=[上级路由ip]    //网关指向上级路由
uci set network.lan.dns=[上级路由ip]    //dns指向上级路由
uci set dhcp.lan.ignore=1    //关掉lan的dhcp

然后是无线

uci set wireless.@wifi-device[0].disabled=0    //打开无线
uci set wireless.@wifi-device[0].txpower=17    //设置功率为17dbm 太高会烧无线模块
uci set wireless.@wifi-device[0].channel=6    //设置无线信道为6
uci set wireless.@wifi-iface[0].mode=ap    //设置无线模式为ap
uci set wireless.@wifi-iface[0].ssid=[自己设置SSID]    //设置无线SSID
uci set wireless.@wifi-iface[0].network=lan    //无线链接到lan上
uci set wireless.@wifi-iface[0].encryption=psk2    //设置加密为WPA2-PSK
uci set wireless.@wifi-iface[0].key=[密码]    //设置无线密码

最后应用配置

uci commit    //应用
/etc/init.d/network restart    //重启网络服务

本文章由 http://www.wifidog.pro/2014/12/29/wifidog-openwrt-%E6%97%A0%E7%BA%BF.html 整理编辑，转载请注明出处